EVINRUDE MANUAL PDF INSTALL

EVINRUDE MANUAL PDF INSTALL

Install clamp and secure with two screws.ДЄfter installation, verify that there is sufficient clearance for Tighten and cut tie strap.ДЎ101 Place grommet or rubber wrap in opening in front of lower engine cover. Twist tie strap around so the connection is facing down to fit in lower engine cover. Models - bundle the electrical cable, the TrimlTilt пј пЅѕ cable, battery cables and the VRO Low Oil Warning wire, and wrap the cables using the piece of rubber wrap В® supplied with the battery cables. Tilt Models - install grommet on battery cables, пј пЅѕ electrical cable and VRO Low Oil Warning wire where they enter front of lower engine cover. Secure cable in clamps on exhaust cover.Д¬onnect negative (black) battery lead to ground Secure the connection with spring clip В® and snap the clip into retainers on exhaust cover. Align arrows В® and push connectors firmly together. Apply OMC Triple-Guard grease to shaped area shown in figure. Ill using the decal on starter motor as your guide. Route the positive (red) battery lead to starter solenoid

Remove cable clamp from front of lower engine cover. Provide sufficient slack at motor end to permit steering and tilting of motor without binding. Sources (sparks) or from contact with moving parts if accidental cranking or starting occurs. Failure to do so could result in injury from ignition Disconnect battery cables before servicing electrical sys.

Evinrude manual pdf